Audio Note Empress Manual do Utilizador

user manualtape delay

Advanced Conguration at a GlancePresets: Choose how many presets are used when in slow or fast mode.left(default): no presetscenter: 2 presetsright:

Advanced Configuration The Empress Tape Delay ships with the following default behaviour: no presets, buffered bypass, and smooth delay time changes.

Exiting the advanced configuration: Hold down both the tap and bypass stompswitches. The bypass LED will blink twice to confirm that the Tape Delay ha

Adjusting the Headroom The Empress Tape Delay has an internal switch which allows for the adjustment of the input headroom. This switch is accessed by

Powering the Tape Delay Go to www.empresseffects.com/power.html for a full list of compatible power supplies. Please Note: The Empress Tape Delay req

Legal Stuff FCC Compliance Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 1

Specifications Input Impedance: 1MΩ Output Impedance: 1kΩ Frequency Response (-3dB): Input Headroom with -6dB pad: Input Headroom with -0dB pad: Input

Introduction During the development of our Vintage Modified Superdelay, we spent over 2 years perfecting the tape modes, painstakingly recreating some

Quick Start Basic tape delay: warm and dark repeats with wow and flutter Dotted eights: rhythmic delay (tap quarter notes on the tap switch)

Quick Start ...continued Ambiance: creates a continuous pad that sits under your playing Slapback delay: a short delay that gives life to your sound

Clean repeats: the clarity of new tape, distinct repeats. Lead Tone: a good delay for soloing that also boosts your volume

The Tap Stompswitch The tap stompswitch does different things depending on which mode it's in. Tap mode: When the delay time toggle is set to &

Using Presets The Empress Tape Delay ships with presets disabled, but can be set to use either 2 or 3 presets, using the advanced configuration. Note

Controls at a GlancePower: 9V DC negative tip 2.1mm jack. 280mA or greater-+delay time: sets the range of the d time|ratio k

Controls at a GlancePower: 9V DC negative tip 2.1mm jack. 280mA or greaterbypass stompswitch: when the LED is shining, the d